Leave Your Message
AI Helps Write

MBUC11700S55A 300W Ku-Band Block Up-converter

Model No.: MBUC11700S55A

The MBUC11700S55A is a 300W solid-state Ku-band block upconverter operating from 10.7 to 12.7 GHz, a frequency range commonly used for satellite downlinks. It combines high-power RF amplification, wideband frequency conversion and an integrated AC power supply in a 12 kg enclosure. Ethernet remote control, adjustable gain and built-in fault protection support outdoor RF transmission systems.

  • P1 (dBm) 50
  • Output Frequency(MHz) 10700-12700
  • Input Frequency(MHz) 950-2950
  • Gain(dB) 75 (min)
  • Gain Flatness(dB) ±1
  • Phase Noise(dBc/Hz@ 1kHz) ≤ −73
  • Gain Control Range(dB) 20
  • Power Consumption(W) 1500
  • Input VSWR 1.5:1

Product introduction

The Mars RF MBUC11700S55A provides a 300W solid-state Ku-band solution for high-power RF transmission within the 10.7–12.7 GHz frequency range, commonly associated with satellite downlink communications. Delivering a minimum saturated output power of 55 dBm and a minimum power gain of 75 dB, it offers a higher output power rating than the 250W model while retaining the same 330 × 200 × 178 mm enclosure and 12 kg weight.

The BUC handles 950–2950 MHz IF signals through a fixed 9.75 GHz local oscillator, producing RF output across the full 2 GHz operating band. A 20 dB gain control range with 0.25 dB steps allows output levels to be adjusted remotely through Ethernet. The external 10 MHz reference input supports frequency synchronization, with automatic transfer to the internal reference when the external signal falls below the specified threshold.

The MBUC11700S55A incorporates an AC power supply rated for 180–230 VAC, 50 Hz operation, with 1500 W typical power consumption. Remote monitoring covers PA switching, temperature and fault status, while built-in protection and warning functions address excessive reflected power, LO unlock, over-current, over-voltage and over-temperature conditions. Its IP65-rated enclosure supports outdoor operation from −40°C to +60°C.

Key Features

Integrated 300W Configuration in a 12 kg Enclosure

2 GHz IF-to-RF Conversion with a Fixed 9.75 GHz LO

20 dB Gain Control with 0.25 dB Adjustment Steps

Ethernet-Based PA Switching, Gain Control and Fault Monitoring

IP65-Rated Outdoor Enclosure with Integrated Protection Functions

May We Also Suggest

Picture
Model No.
Data Sheet
Start(MHz)
Stop(MHz)
Pout(Watts)
Gain(dB)
Voltage(V)
Mode
Size(mm)
Quote
800
1000
200
53
28
CW
200x150x25
RF Broadband High Power Amplifiers KB002052M47A
RF Broadband High Power Amplifiers KB002052M47A pdf
800
1000
200
53
28
CW
200x150x25
Get QuoteStock : 7
RF Broadband High Power Amplifiers KB0001003M53A
Start:1.5
Stop:30
Pout:200
Gain:53
Size:200x150x30